Platformlift moves vertical

 

NTD B300 is a simple screw and nut-driven platform lift which moves vertical, primarily intended for outdoor use. The NTD B300 can also be installed indoors and it has a max. lifting height of 3 metres. The open design is covered by toughened and laminated glazed panels, providing a stylish and reliable platform. The nominal load is 300 kg. The NTD B300 is very easy to install. It is used as a wheelchair lifter or platform lift, typical outdoor.

No pit is required
The NTD B300 does not require a pit since it is delivered with a built-in ramp. Easy to use The double doors swing back to the open or closed position. The platform which moves vertical is operated via “hold to run”, and the controls on and off the platform are easy to use.

Safety first
Safety is very important for open platform lifts. To prevent crushing injuries when the lift is lowered, the underside of the platform is covered with a contact plate, which stops the lift immediately on contact with an object. It has very high reliability.

Cost efficient
The installation is very cost efficient. The lift is delivered in two parts: a guide frame that is screwed in place and a platform that is hung on the guide frame. Then, connect the electrical power and the lift is ready to use.

Tested and certified
The NTD B300 is constructed, tested and approved according to the Machinery Directive and it conforms to all applicable European standards. It is EC type approved and certified by Det Norske Veritas (DNV). The lift is CE marked and comes with a Declaration of Conformity.

If you want the product info of this lift type to be send to you by email automatically, then fill in the form below.
 *
name@company.com
 *
 *
 *
016-1234567 or 03-1234 5678

Technical specifications B300

Feature

Description Feature Description
Manufacturer NTD Lifts AB Sweden Speed 0.15m/sec
Rated load 300kg Platfrom dimensions 1050 x 1450mm (width x length)
Drive system Screw and nut drive External dimensions 1300 x 1890mm (width x length)
Lifting height max 3 meter (2 stops) Doors Double doors with hardened laminate glass (saloon doors)
Speed <6cm/sec Power supply standard 400 Volt 3 phase 50/60Hz; 10Amp start current. Soft start and stop are optional. (230Volt 1 or 3 phase frequency control; 16A)
Operating system Hold to run Motor power 1.1kWatt
Pit No Operating voltage 24Volt
Surface treatment Powder coated in RAL 7031; alternative hot galvanized. Optional: another RAL colour.